Product Manual
Table Of Contents
- 1 CALIFORNIA Proposition 65 Warning
- 2 Preface
- 3 Introduction
- 4 Security
- 4.1 Policy
- 4.2 Proper use
- 4.3 Structural changes
- 4.4 Areas of responsibility of the operator
- 4.5 Operator responsibilities
- 4.6 Personnel qualification
- 4.7 Residual dangers
- 4.8 General safety instructions
- 4.9 Specific safety instructions - Vibratory rammer AS
- 4.10 General safety instructions – fuel, lubricants and coolants
- 4.11 Maintenance
- 4.12 General safety instructions - Rechargeable battery (accessories)
- 4.13 General safety instructions - Battery charger (accessories)
- 4.14 Personal Protective Equipment
- 4.15 Behavior in dangerous situations
- 5 Safety and information labels
- 6 Setup and function
- 7 Components and operator's controls
- 8 Transport
- 9 Storage
- 10 Operation and use
- 11 Maintenance
- 12 Troubleshooting
- 13 Disposal
- 14 Disposal
- 15 Accessories
- 16 Technical data
- 17 Glossary
10 Operation and use
24 100_0201_op_0006.fm
10 Operation and use
10.1 Before commissioning
10.1.1 Inspection before commissioning
Check the machine and components for damage. In the event of visible damage, do not operate the
machine and immediately contact a Wacker Neuson dealer.
Check the switching and safety lever for smooth and effortless movement.
Ensure that loose packaging material has been removed from the machine.
Current regulations of the local authorities for noise emissions.
Charge situation of rechargeable battery.
Lubricating grease or oil.
Check the screwed connections for a secure seat.
10.1.2 Charge and deploy rechargeable battery
Charge the rechargeable battery
1. Place the battery charger and rechargeable battery on a dry and clean working area.
2. Connect the battery charger to the power source.
3. Then connect the rechargeable battery to the battery charger.
4. Check the charge situation of battery regularly.
5. If the rechargeable battery is completely charged, unplug the rechargeable battery from the battery
charger and de-energize the battery charger.
Deploy the rechargeable battery
1. Hold the vibratory rammer firmly by the control handle with one hand.
2. Position the starter-/gearlever of the vibratory rammer in the OFF position.
WARNING
Improper handling may result in injury or serious material damage.
Please read and follow all safety instructions in this operator's manual.
NOTICE
Perform control procedures according to the Maintenance chapter. If necessary, top off
missing fuel, lubricants and coolants, see chapterTechnical Data.
NOTICE
Only use battery chargers and rechargeable batteries from Wacker Neuson.
NOTICE
The electrical contacts and contact surface of the rechargeable battery must be clean and
dry.
Item Designation Item Designation
1 Rechargeable battery 2 Starter lever
1
2