Product Manual

12 Maintenance
100_0101_mt_0012.fm 29
12.2.1 Visual inspection for damage and leaks
 Check all components for damage.
 Check the seal of the switch membrane of the on/off switch against leakage.
 Check the flat-faced sealing surfaces/soft components of the Quickflex coupling for damage and
impurities.
12.2.2 Check to ensure the connection link is firmly seated
Check to ensure the connection link between the IRflex vibrator head and the FUflex inverter is firmly
seated.
 If necessary, screw together the Quickflex coupling as tightly as possible, tighten the retaining screw
and attach the protective cap.
12.2.3 Check wear dimensions of the vibrator head
The wear dimensions are:
 Minimum diameter bottom of the pipe øL
L
 Minimum diameter bottom of the vibrator head øL
 Length of the vibrator head L
L
The wear is highest at the end of the vibrator head.
If a wear dimension is reached at one point, have the vibrator head exchanged by your Wacker Neuson
contact partner’s service.
Dimensions in bold are wear dimensions.
Dimensions in brackets are original dimensions of a new machine.
WARNING
Damage to the machine or power cable can lead to physical injury from electric shock.
 Do not operate a damaged machine.
 Have damaged machine repaired immediately.
Machine type Dimensions of the vibrator head and bottom of the pipe [mm]
øL
L
L
L
øL L
IRflex30 28 (30) 347 (353) -* -*
IRflex38 33 (38) 338 (345) 36 (38) (218)
IRflex45 38 (45) 372 (382) 42 (45) (333)
IRflex58 50 (58) 390 (400) 54 (58) (253)
*
Vibrator head is not divided.