User`s manual

Chapter 5, Operating Instructions: Operating the Machine with the UCP
Wachs Subsea 06-150-520-MAN 33
Figure 5-15. Connect the hydraulic drive hoses to the
saw as shown.
Clamping the Saw to the Workpiece
1.
Position the saw at the cutting location on the pipe,
with the saddle against the pipe surface.
2.
Start the hydraulic power unit.
3.
Use the clamping controls on the UCP to clamp the
saw to the pipe.
Cutting drive
pressure
Autofeed drive
pressure
Autoclamp
drive pressure
Autoclamp
drive return
Autofeed drive
return
Cutting drive
return