User`s manual

Chapter 5, Operating Instructions: Using the Autofeed
Wachs Subsea 06-150-520-MAN 31
Figure 5-13. Tighten the clamp knob on both clamp
blocks to secure the blade for cutting.
USING THE AUTOFEED
The hydraulic autofeed is operated using the feed controls
on the universal control panel (UCP). A separate hydraulic
motor turns the autofeed drive, with the speed set inde-
pendently of the cutting speed.
The hydraulic autofeed mechanism is shown below. Instruc-
tions for operating the hydraulic autofeed are in the section
of this chapter titled “Operating the Machine with the
UCP”.