User`s manual

Autoclamp Goliath Guillotine Pipe Saw

10 06-150-520-MAN Wachs Subsea

• Do not mount the Guillotine on the “fall-off” side of the

cut line, unless you adequately rig and support the Guil-

lotine and workpiece.

• Do not disable any safety feature of the Guillotine or

remove any safety labeling. Replace worn or damaged

safety labels immediately. (See “Safety and Operation

Labels” later in this chapter.)

Potential Hazards

Figure 2-1 illustrates potential hazards of operating the

Guillotine pipe saw. Refer to the description of each hazard

for guidelines on safe operation.

A. Moving Parts Hazard—Keep

away from the oscillating saw

bow and all moving parts

while the machine is operat-

ing.

B. Pipe Saddle Mounting

Point—Keep hands and feet

clear when mounting and

moving the saw on the work-

piece.

C. Cutting Zone—Keep away

from the saw blade while the

machine is operating. Use

care when handling the saw

blade and cutting debris.

Figure 2-1. Potential operating hazards of the Guillo-

tine saw. See the descriptions in the side column.

Guidelines for Safe Setup, Operation, and

Service

Pre-Operation Checklist

Every time you use the Guillotine, perform the following

checks to make sure it is in good operating condition: