User`s manual

Chapter 5, Operating Instructions: Operating the Machine with the Topside Control Unit
E.H. Wachs Company Part No. 06-150-520-MAN, Rev. 0-0607 51
Figure 5-51. When the cut is complete, set the cutting
speed lever back to 0. Then return the cutting drive
lever to the off (up) position.
11.
To reverse the feed and move the saw bow back to the
start position, set the feed direction lever to the
REVERSE position and use the feed drive lever to
operate the drive. You may have to remove the blade
first to prevent it from binding on the pipe.
Removing the Saw
1.
Slowly raise the lift holding the saw until there is just
enough tension to hold the saw in place.
2.
Set the clamping direction lever to the RETRACT
position.