User`s manual

Goliath Guillotine Pipe Saw
48 Part No. 06-150-520-MAN, Rev. 0-0607 E.H. Wachs Company
Figure 5-46. With the feed direction lever in the FOR-
WARD position, move the feed drive lever (shown here
in the up position) down to start the drive. Then move
the feed speed lever to start flow to the feed drive.
4.
Set the cutting drive lever for the speed you want.
Typically, you can set it to the maximum.
Figure 5-47. Set the cutting speed lever to the desired
cutting speed.
5.
Allow the saw to operate at a slow feed rate until the
blade has parted through the near wall of the pipe.