User`s manual

Chapter 5, Operating Instructions: Operating the Machine with the Topside Control Unit
E.H. Wachs Company Part No. 06-150-520-MAN, Rev. 0-0607 47
You may need to
remove the blade
before retracting
the bow.
5.
Using the feed handle on the end of the feed screw,
retract the saw bow fully from the workpiece.
Figure 5-45. Turn the feed handle clockwise to retract
the saw bow. (Note that the handle can be mounted on
either end of the feed screw. Turn it counter-clockwise
if it is on the saddle end of the screw.)
Hydraulic Autofeed
1.
Set the feed direction lever to the FORWARD posi-
tion, as shown in Figure 5-46.
2.
Open the feed drive lever by pushing it down.
3.
Adjust the feed speed lever until the feed motion
starts. Set the lever to the desired speed.
Feed handle