User`s manual

Chapter 5, Operating Instructions: Operating the Machine with the Topside Control Unit
E.H. Wachs Company Part No. 06-150-520-MAN, Rev. 0-0607 45
Figure 5-41. Push the cutting drive lever down to
open it.
3.
Move the cutting drive speed lever up gradually.
When sufficient flow reaches the saw, the saw bow
will begin the cutting motion.
Figure 5-42. Push the cutting speed lever up slowly
until the saw motion begins.
Mechanical Autofeed
1.
Egage the autofeed mechanism, or feed the saw manu-
ally into the pipe.
2.
Set the cutting drive lever for the speed you want.
Typically, you can set it to the maximum.