User`s manual

Goliath Guillotine Pipe Saw
44 Part No. 06-150-520-MAN, Rev. 0-0607 E.H. Wachs Company
6.
Close both clamping drive levers (up position) at the
same time. The valves will hold pressure on the
clamping drive to keep the saw clamped on the pipe.
Figure 5-39. When the clamping drive is fully
engaged (clamping pressure equals system pressure),
return both clamping levers to the up position.
7.
Slightly lower the crane holding the saw to allow the
clamp to hold the saw’s weight. Leave the crane
attached to the saw.
Operating the Saw
WARNING
IMPORTANT
Always support
the workpiece
securely on both sides of the
cutting location. Any unse-
cured section of the work-
piece could shift or fall during
cutting, damaging the equip-
ment or causing injury to an
operator.
1.
Make sure the cutting drive speed control lever is set
to 0.
Figure 5-40. Set the cutting drive speed lever to 0
before starting the saw.
2.
Open the cutting drive lever (down position).