User`s manual

Chapter 5, Operating Instructions: Operating the Machine with the Topside Control Unit
E.H. Wachs Company Part No. 06-150-520-MAN, Rev. 0-0607 43
Figure 5-37. Before clamping, make sure that both
clamping levers and the cutting lever are in the up
position, and that the clamping direction lever is in the
ENGAGE position.
5.
Open both clamping drive levers (down position) at
the same time to engage the autoclamp drive. When
the clamp pressure equalizes with the system pressure,
the clamp is fully engaged against the pipe.
Figure 5-38. Put both clamping levers down at the
same time to engage the clamping drive.