User`s manual

Chapter 5, Operating Instructions: Operating the Standard Machine
E.H. Wachs Company Part No. 06-150-520-MAN, Rev. 0-0607 37
Figure 5-27. Turn the feed handle clockwise to retract
the saw bow. (Note that the handle can be mounted on
either end of the feed screw. Turn it counter-clockwise
if it is on the saddle end of the screw.)
Removing the Saw
1.
Raise the crane or lift to put tension on the chains
holding the saw.
WARNING
IMPORTANT
Be sure the crane
is supporting the
saw before you loosen the
clamping chain. The saw
could shift or fall, injuring an
operator or damaging the
equipment.
2.
Using the 2-1/2” end wrench, loosen the chain ten-
sioning nut by turning it counter-clockwise. Turn the
nut all the way back to release the chain.
Figure 5-28. Turn the chain tensioning nut counter-
clockwise to loosen the chain.
Feed handle