User`s manual

Goliath Guillotine Pipe Saw
30 Part No. 06-150-520-MAN, Rev. 0-0607 E.H. Wachs Company
3.
With the saw running, pull out the lockout pin to
release the feed lever.
Figure 5-16. Pull out the lockout pin and release the
feed lever to engage the autofeed.
4.
The feed screw will turn until the autofeed notch
engages the lockout pin. The pin will hold the feed
screw stationary, allowing the saw bow to advance.
Hydraulic Autofeed
The hydraulic autofeed is operated using the feed controls
on the topside control unit (TCU). A separate hydraulic
motor turns the autofeed drive, with the speed set indepen-
dently of the cutting speed.
The hydraulic autofeed mechanism is shown in fig. Instruc-
tions for operating the hydraulic autofeed are in the section
of this chapter titled “Operating the Machine with the Top-
side Control Unit”.