User`s manual

Chapter 5, Operating Instructions: Using the Autofeed
E.H. Wachs Company Part No. 06-150-520-MAN, Rev. 0-0607 29
Figure 5-14. To double the feed rate, use a pliers to
pull the secondary trip pin down until it snaps into
place. Slide it back up into the cam wheel to set the
feed rate back to the standard speed.
1.
Make sure the autofeed is disengaged when starting
the saw motion. The feed lockout pin will be pushed
in to disengage the feed.
Figure 5-15. Push the feed lever up to the disengaged
position and push in the lockout pin.
2.
Engage power to the saw according to the instructions
in the appropriate section below.
Secondary trip pin
Primary trip pin