User`s manual

Goliath Guillotine Pipe Saw
28 Part No. 06-150-520-MAN, Rev. 0-0607 E.H. Wachs Company
Figure 5-13. The photo shows the mechanical feed
drive components.
When the autofeed is disengaged, the feed screw turns
freely and does not move the bow. Engaging the autofeed
locks the feed screw, allowing the feed worm gear to index
the bow into the workpiece with each revolution of the
wheel cam.
The feed rate is approximately 0.008” per saw cycle. A sec-
ond trip pin in the wheel cam allows you to double the feed
rate. With the saw off, slide the second pin down out of the
wheel until it locks in place. The wheel motion will then trip
the feed shaft twice during each saw cycle.
Feed screw Feed worm
Trip pin Feed shaft
Feed worm gear
Cam wheel