User`s manual

Chapter 3, Introduction to the Goliath: Machine Control
E.H. Wachs Company Part No. 06-150-520-MAN, Rev. 0-0607 11
MACHINE CONTROL
The topside control unit (TCU) provides remote controls for
up to three hydraulic drives. On the Goliath Guillotine, one
drive controls the saw motion, and two are used for options:
the autoclamp mechanism and the hydraulic autofeed.
Instructions for operating the saw using the TCU are in
Chapter 5.
Figure 3-3. The topside control unit (TCU) has con-
trols for the cutting and optional clamping and feed
drives on the Goliath Guillotine. It has inputs for
hydraulic power and separate outputs and controls for
up to three drives.
For use with the TCU, the Goliath is fitted with a hydraulic
connector bulkhead, as shown in Figure 3-4 and Figure 3-5.