User`s manual

Chapter 5: Operating Instructions Goliath Guillotine Pipe Saw
52 Part No. 98-037-011-MAN, Rev. 3-0906 E.H. Wachs Company
4.
Close both clamping drive levers (up position) at the
same time.
Figure 5-60. When the clamping drive is fully
retracted (clamping pressure equals system pressure),
return both clamping levers to the up position.
5.
Set the clamping direction lever back to the ENGAGE
position for the next operation.
Figure 5-61. When the clamp has been retracted,
move the clamping direction lever back to the
ENGAGE position.
6.
Use the crane to remove the saw from the workpiece.
7.
If you are finished with the saw, turn off the HPU. Set
the saw in its storage location and disconnect the
hoses.