User`s manual

Goliath Guillotine Pipe Saw Chapter 5: Operating Instructions

E.H. Wachs Company Part No. 98-037-011-MAN, Rev. 3-0906 51

counter-clockwise if it is on the saddle end of the

screw.)

Removing the Saw

Slowly raise the lift holding the saw until there is just

enough tension to hold the saw in place.

Set the clamping direction lever to the RETRACT

position.

Figure 5-58. Set the clamping direction lever to the

RETRACT position.

Open both clamping drive levers (down position) at

the same time to retract the autoclamp drive. When the

clamp pressure equalizes with the system pressure, the

clamp is fully retracted.

Figure 5-59. Put both clamping levers down at the

same time to retract the clamping drive.