User`s manual

Goliath Guillotine Pipe Saw Chapter 5: Operating Instructions
E.H. Wachs Company Part No. 98-037-011-MAN, Rev. 3-0906 49
Figure 5-54. Push the cutting speed lever up slowly
until the saw motion begins.
4.
Engage the autofeed mechanism, or feed the saw man-
ually into the pipe.
5.
Set the cutting drive lever for the speed you want.
Typically, you can set it to the maximum.
Figure 5-55. Set the cutting speed lever to the desired
cutting speed.
6.
If the saw begins to chatter or bind, slow the cutting
speed lever.
7.
When the cut is complete, set the cutting speed lever
back to 0. Close the cutting drive lever by moving it to
the up position.