User`s manual

Chapter 5: Operating Instructions Goliath Guillotine Pipe Saw
48 Part No. 98-037-011-MAN, Rev. 3-0906 E.H. Wachs Company
Operating the Saw
WARNING
IMPORTANT
Always support
the workpiece
securely on both sides of the
cutting location. Any unse-
cured section of the work-
piece could shift or fall during
cutting, damaging the equip-
ment or causing injury to an
operator.
1.
Make sure the cutting drive speed control lever is set
to 0.
Figure 5-52. Set the cutting drive speed lever to 0
before starting the saw.
2.
Open the cutting drive lever (down position).
Figure 5-53. Push the cutting drive lever down to
open it.
3.
Move the cutting drive speed lever up gradually.
When sufficient flow reaches the saw, the saw bow
will begin the cutting motion.