User`s manual

Goliath Guillotine Pipe Saw Chapter 5: Operating Instructions

E.H. Wachs Company Part No. 98-037-011-MAN, Rev. 3-0906 47

Figure 5-50. Put both clamping levers down at the

same time to engage the clamping drive.

Close both clamping drive levers (up position) at the

same time. The valves will hold pressure on the

clamping drive to keep the saw clamped on the pipe.

Figure 5-51. When the clamping drive is fully

engaged (clamping pressure equals system pressure),

return both clamping levers to the up position.

Slightly lower the crane holding the saw to allow the

clamp to hold the saw’s weight. Leave the crane

attached to the saw.