User`s manual

Chapter 5: Operating Instructions Goliath Guillotine Pipe Saw
46 Part No. 98-037-011-MAN, Rev. 3-0906 E.H. Wachs Company
Clamping the Saw to the Workpiece
1.
Position the saw at the cutting location on the pipe,
with the saddle against the pipe surface.
2.
Start the hydraulic power unit.
3.
Make sure that the clamping drive levers and the cut-
ting drive lever on the TCU are in the closed (up) posi-
tion, as shown in Figure 5-49.
4.
Set the clamping direction lever on the TCU to the
ENGAGE position.
Figure 5-49. Before clamping, make sure that both
clamping levers and the cutting lever are in the up
position, and that the clamping direction lever is in
the ENGAGE position.
5.
Open both clamping drive levers (down position) at
the same time to engage the autoclamp drive. When
the clamp pressure equalizes with the system pressure,
the clamp is fully engaged against the pipe.