User`s manual

Chapter 5: Operating Instructions Goliath Guillotine Pipe Saw
40 Part No. 98-037-011-MAN, Rev. 3-0906 E.H. Wachs Company
5.
If the saw binds or chatters while cutting, disengage
the autofeed for a few cycles.
6.
When the cut is complete, disengage the autofeed.
7.
Turn off power to the saw by lifting the cutting drive
lever back to the up position.
Figure 5-37. Lift the cutting drive lever to stop the
saw motion.
You may need to
remove the blade
before retracting
the bow.
8.
Using the feed handle on the end of the feed screw,
retract the saw bow fully from the workpiece.
Figure 5-38. Turn the feed handle clockwise to
retract the saw bow. (Note that the handle can be
mounted on either end of the feed screw. Turn it
counter-clockwise if it is on the saddle end of the
screw.)
Feed handle