User`s manual

Goliath Guillotine Pipe Saw Chapter 5: Operating Instructions
E.H. Wachs Company Part No. 98-037-011-MAN, Rev. 3-0906 39
Operating the Saw
WARNING
IMPORTANT
Always support
the workpiece
securely on both sides of the
cutting location. Any unse-
cured section of the work-
piece could shift or fall during
cutting, damaging the equip-
ment or causing injury to an
operator.
1.
Make sure the autofeed lever is disengaged, with the
feed lockout pin pushed in.
Figure 5-35. The feed lever should be disengaged and
the lockout pin pushed in.
2.
Make sure the HPU is providing 2000 psi pressure.
3.
Push the cutting drive lever down to engage the saw
bow motion.
Figure 5-36. Push the cutting drive lever down to
start the saw motion.
See “Using the
Autofeed” earlier in
this chapter.
4.
To engage the cut, pull out the autofeed lockout pin to
release the feed lever. The feed screw will engage and
the bow will index into the workpiece.