User`s manual
Goliath Guillotine Pipe Saw Chapter 5: Operating Instructions
E.H. Wachs Company Part No. 98-037-011-MAN, Rev. 3-0906 33
Figure 5-26. Turn the feed handle clockwise to
retract the saw bow. (Note that the handle can be
mounted on either end of the feed screw. Turn it
counter-clockwise if it is on the saddle end of the
screw.)
Removing the Saw
1.
Raise the crane or lift to put tension on the chains
holding the saw.
WARNING
IMPORTANT
Be sure the crane
is supporting the
saw before you loosen the
clamping chain. The saw
could shift or fall, injuring an
operator or damaging the
equipment.
2.
Using the 2-1/2” end wrench, loosen the chain ten-
sioning nut by turning it counter-clockwise. Turn the
nut all the way back to release the chain.
Feed handle