User`s manual

Chapter 5: Operating Instructions Goliath Guillotine Pipe Saw
32 Part No. 98-037-011-MAN, Rev. 3-0906 E.H. Wachs Company
Figure 5-24. Open the flow valve (up position) to
engage the saw cutting motion.
See “Using the
Autofeed” earlier in
this chapter.
5.
To engage the cut, pull out the autofeed lockout pin to
release the feed lever. The feed screw will engage and
the bow will index into the workpiece.
6.
If the saw binds or chatters while cutting, disengage
the autofeed for a few cycles.
7.
When the cut is complete, disengage the autofeed.
8.
Turn off power to the saw by closing the flow valve
(bypass position).
Figure 5-25. Close the flow valve to stop the saw.
You may need to
remove the blade
before retracting
the bow.
9.
Using the feed handle on the end of the feed screw,
retract the saw bow fully from the workpiece.