User`s manual

Goliath Guillotine Pipe Saw Chapter 5: Operating Instructions
E.H. Wachs Company Part No. 98-037-011-MAN, Rev. 3-0906 31
Operating the Saw
WARNING
IMPORTANT
Always support
the workpiece
securely on both sides of the
cutting location. Any unse-
cured section of the work-
piece could shift or fall during
cutting, damaging the equip-
ment or causing injury to an
operator.
1.
Make sure the flow valve on the saw is set to the
bypass (off) position.
NOTICE:
The lifting device
should be attached
to the saw during cutting, but
make sure there is slack in
the chain at all times.
Figure 5-22. Make sure the flow valve is off before
starting the saw.
2.
Make sure the autofeed lever is disengaged, with the
feed lockout pin pushed in.
Figure 5-23. The feed lever should be disengaged and
the lockout pin pushed in.
3.
Turn on the hydraulic power unit and ensure that it is
operating at 1500 psi (103 bar).
4.
Slowly open the flow valve on the saw to start the cut-
ting motion. Open the valve all the way.
Flow valve in bypass (off) position