User`s manual

Chapter 5: Operating Instructions Goliath Guillotine Pipe Saw
30 Part No. 98-037-011-MAN, Rev. 3-0906 E.H. Wachs Company
Figure 5-20. Insert the chain cross pin into the screw
hook.
Tighten the clamp-
ing chain as tight
as you can get it
with the end wrench.
4.
Using a 2-1/2” end wrench supplied with the saw,
tighten the chain tensioning nut by turning it clock-
wise until the chain is secure.
Figure 5-21. Turn the chain tensioning nut clockwise
to secure the saw to the workpiece.
5.
Release the crane slightly to allow the clamping chain
to support the weight of the saw. Leave the crane
attached to the saw while cutting.