User`s manual

Chapter 5: Operating Instructions Goliath Guillotine Pipe Saw
28 Part No. 98-037-011-MAN, Rev. 3-0906 E.H. Wachs Company
There is no flow/
speed control on
the standard Goli-
ath. If your HPU does not
have speed control, call E.H.
Wachs Company to request
an optional flow control valve
assembly.
2.
Connect the return hose to the return side connector on
the saw.
Figure 5-17. Connect the hydraulic hoses to the con-
nectors on the Goliath. When the flow valve is in the
bypass position (as shown), the saw motion is dis-
abled.
Clamping the Saw to the Workpiece
IMPORTANT
It is recommended
that you mount the
saw to the workpiece without
the blade installed. The blade
could be damaged if the saw
strikes the workpiece during
positioning.
Before mounting the saw on the workpiece, make sure the
bow is fully retracted. If necessary, turn the manual feed
handle clockwise until it tops out.
Pressure side (from HPU)
Return side (to HPU)
Flow valve (in bypass position)