User`s manual

Goliath Guillotine Pipe Saw Chapter 5: Operating Instructions
E.H. Wachs Company Part No. 98-037-011-MAN, Rev. 3-0906 27
2.
Engage power to the saw according to the instructions
in the appropriate section below.
3.
With the saw running, pull out the lockout pin to
release the feed lever.
Figure 5-16. Pull out the lockout pin and release the
feed lever to engage the autofeed.
4.
The feed screw will turn until the autofeed notch
engages the lockout pin. The pin will hold the feed
screw stationary, allowing the saw bow to
OPERATING THE STANDARD MACHINE
Follow the instructions in this section to set up and operate
the standard Goliath Guillotine (configured without auto-
clamp or topside controls).
Connecting the Hoses
1.
Connect the hydraulic pressure hose to the pressure
side connector (with the flow bypass valve) on the
saw.