User`s manual

Goliath Guillotine Pipe Saw Chapter 5: Operating Instructions
E.H. Wachs Company Part No. 98-037-011-MAN, Rev. 3-0906 25
Figure 5-13. The photo shows the feed drive compo-
nents.
When the autofeed is disengaged, the feed screw turns
freely and does not move the bow. Engaging the autofeed
locks the feed screw, allowing the feed worm gear to index
the bow into the workpiece with each revolution of the
wheel cam.
The feed rate is approximately 0.008” per saw cycle. A sec-
ond trip pin in the wheel cam allows you to double the feed
rate. With the saw off, slide the second pin down out of the
wheel until it locks in place. The wheel motion will then trip
the feed shaft twice during each saw cycle.
Feed screw Feed worm
Trip pin Feed shaft
Feed worm gear
Cam wheel