User`s manual

Chapter 5: Operating Instructions Goliath Guillotine Pipe Saw

22 Part No. 98-037-011-MAN, Rev. 3-0906 E.H. Wachs Company

Unscrew the clamp knob on the left clamp block

almost to the top of the screw. You will need to lift the

block high enough to raise the dowel pins out of the

bow.

Figure 5-9. Loosen the clamp knob on the left clamp

block so that you can raise the dowel pins out of the

saw bow.

IMPORTANT

Install the blade so that the

teeth point to the left.

Holding the block up, slide the end of the blade under

the block so that the hole in the blade is lined up

beneath the dowel pin.

Set the clamp block down with the dowel pin through

the hole in the blade. Tighten the clamp knob with

your fingers until it is just snug.

Unscrew the clamp knob on the right block and lift the

block to insert the other end of the blade.

Set the right block back down with the dowel pin

through the hole in the blade and tighten the clamp

knob until it is just snug.

teeth point to left