User`s manual

Chapter 3: Introduction to the Goliath Guillotine Goliath Guillotine Pipe Saw
12 Part No. 98-037-011-MAN, Rev. 3-0906 E.H. Wachs Company
Topside Control Unit
The topside control unit (TCU) provides remote controls for
up to three hydraulic drives. The Goliath Guillotine uses
two hydraulic drives, one for the saw motion and autofeed,
and one for the optional autoclamp feature.
Instructions for operating the saw using the TCU are in
Chapter 5.
Figure 3-5. The topside control unit (TCU) has con-
trols for the clamping and cutting drives on the Goli-
ath Guillotine. It has inputs for hydraulic power and
separate outputs and controls for up to three drives.
For use with the TCU, the Goliath is fitted with a hydraulic
connector bulkhead, as shown in Figure 3-6.