User`s manual

Chapter 5, Operating Instructions: Operating the Machine

E.H. Wachs Company Part No. 06-150-522-MAN, Rev. 1-0710 35

WARNING

IMPORTANT

Be sure the crane

is supporting the

saw before you loosen the

clamping chain. The saw

could shift or fall, injuring an

operator or damaging the

equipment.

Using the 2-1/2” end wrench, loosen the chain ten-

sioning nut by turning it counter-clockwise. Turn the

nut all the way back to release the chain.

Figure 5-29. Turn the chain tensioning nut counter-

clockwise to loosen the chain.

Remove the chain cross pin from the screw hook and

unwrap the chain from the workpiece.

Carefully move the saw away from the workpiece

with the crane.

Remove the hoses from the saw manifold.

To retract the hoses in the hose reel, insert the hand

crank through the hole in the front of the case and

install it on the shaft. The inside of the crank end has a

“screwdriver” fitting that locks into the slot on the end

of the shaft.