User`s manual

Goliath Guillotine Pipe Saw
34 Part No. 06-150-522-MAN, Rev. 1-0710 E.H. Wachs Company
IMPORTANT
If you are retract-
ing the bow with
the saw still
attached at the cutting posi-
tion, make sure the cutting
drive is still running or you
could break the blade.
8.
To retract the saw bow before removing the saw, push
the feed lever on the manifold to the left to retract.
When the bow is fully retracted, move the lever back
to the center position.
Figure 5-27. Push the feed lever to the left to retract
the saw bow.
9.
Move the cutting lever back to the center position to
stop the cutting drive.
Figure 5-28. When the bow is retracted, move the cut-
ting lever to the center to turn off the cutting motion.
10.
Turn off power to the saw at the hydraulic power unit.
Removing the Saw
1.
Raise the crane or lift to put tension on the chains
holding the saw.