User`s manual

Chapter 5, Operating Instructions: Operating the Machine
E.H. Wachs Company Part No. 06-150-522-MAN, Rev. 1-0710 33
WARNING
IMPORTANT
When the saw is
installed in cut-
ting position, never operate
the feed drive without the cut-
ting drive motion engaged.
4.
To engage the cut, push the autofeed lever to the right.
The feed screw will engage and the bow will index
into the workpiece.
Figure 5-25. Start the feed motion by pushing the bot-
tom lever to the right. The cutting drive lever must be
engaged when you do this.
5.
If the saw binds or chatters while cutting, disengage
the autofeed for a few cycles.
6.
When the cut is complete, disengage the autofeed by
moving the bottom lever back to the center position.
Figure 5-26. When the cut is complete, move the feed
lever back to the center (off) position.
7.
If you want to remove the saw before retracting the
saw bow, remove the blade from the saw.