User`s manual

Goliath Guillotine Pipe Saw
32 Part No. 06-150-522-MAN, Rev. 1-0710 E.H. Wachs Company
Operating the Saw
WARNING
IMPORTANT
Always support
the workpiece
securely on both sides of the
cutting location. Any unse-
cured section of the work-
piece could shift or fall during
cutting, damaging the equip-
ment or causing injury to an
operator.
1.
Make sure the cutting and autofeed drive control
levers are off (in the center position).
Figure 5-23. Make sure both drive levers are in the off
(center) position.
NOTICE:
The lifting device
should be attached
to the saw during cutting, but
make sure there is slack in
the chain at all times.
2.
Turn on the hydraulic power unit and ensure that it is
operating at 1500 psi (103 bar).
3.
Turn on the cutting drive on the saw by moving the
top lever to the right.
Figure 5-24. Turn on the cutting drive by pushing the
lever to the right.