User`s manual

Goliath Guillotine Pipe Saw
30 Part No. 06-150-522-MAN, Rev. 1-0710 E.H. Wachs Company
IMPORTANT
Carefully position
the hoses as you
move the saw so that they do
not snag on something or
interfere with the moving
parts of the saw.
2.
Lift the saw and position it so that the saddle is against
the workpiece. Wrap the clamping chain around the
workpiece and pull it snug.
Figure 5-19. With the crane holding the saw in place,
wrap the clamping chain around the workpiece.
3.
Insert the closest cross pin of the chain into the clamp
screw hook.
Figure 5-20. Insert the chain cross pin into the screw
hook.
Tighten the clamp-
ing chain as tight
as you can get it
with the end wrench.
4.
Using a 2-1/2” end wrench supplied with the saw,
tighten the chain tensioning nut by turning it clock-
wise until the chain is secure.