User`s manual

Chapter 5, Operating Instructions: Operating the Machine
E.H. Wachs Company Part No. 06-150-522-MAN, Rev. 1-0710 29
Figure 5-17. Connect the hoses from the reel to the
connectors on the manifold.
Clamping the Saw to the Workpiece
IMPORTANT
It is recommended
that you mount the
saw to the workpiece without
the blade installed. The blade
could be damaged if the saw
strikes the workpiece during
positioning.
Before mounting the saw on the workpiece, make sure the
bow is fully retracted. If necessary, retract the autofeed
under hydraulic power.
Figure 5-18. Push the autofeed lever to the left to
retract the saw bow. You will need to have hydraulic
power on to operate the autofeed drive.
1.
Attach the saw to a crane or lift as described in “Lift-
ing the Saw” earlier in this chapter.
Hose connectors