User`s manual

Chapter 3, Introduction to the Goliath: Machine Control
E.H. Wachs Company Part No. 06-150-522-MAN, Rev. 1-0710 11
MACHINE CONTROL
A two-drive hydraulic control manifold is available for on-
machine control. Figure 3-3 illustrates the manifold and
control levers. The hydraulic connectors are labeled P (for
pressure) and T (for tank, or return) on the manifold.
Figure 3-3.
An optional compressed-air cooling/chip removal system is
available, as shown in Figure 3-4 and Figure 3-4.
Figure 3-4. You can attach a standard compressed air
line to the port of the cooling/chip removal system.
Return (tank) fitting
Pressure fitting
Cutting drive lever Autofeed drive lever
Compressed air port
Nozzles