User Manual

Programming kit SFUR0KIT
3
4. How to start
Once the software and drivers have been successfully installed, the system is ready to use.
The following paragraph will suggest some basic steps in order to get acquainted with the
application and verify the correct operation of all parts.
Connect the Programming module to an USB port of your PC by means of the cable
supplied with the kit.
A) If drivers have been installed correctly, after a few seconds the system will confirm the new
hardware as shown in Figure 2.
Figure 2:
B) Connect Programming module with the unit.
The kit will be delivered with two different Programming modules. The module with the
sticker “UA-Serie“ is suitable for Wachendorff Universal displays series UAxxxxxx. The
module with the sticker “UR/TH/TI/VZ/ZD/TA-Serie“ is usable for units of the series
URxxxxxx, TAxxxxxx, THxxxxxx, TIxxxxxx, VZxxxxxx and ZDxxxxxx. The correct positioning
of the Programming module on the controller UR484802 will be shown in figure 3. The USB
power is enough to turn the device on when the communication starts (UR3274Sx from 2.xx
version).
Figure 3: Inserting Programming module on UR4848xx
C) Start Wachendorff Anzeigen-Regler Software
The toolbar includes an area labelled as “Serial port:” which contains all options related to
communication with the device. Make sure that option “Auto” is selected and that value for
field “Slave ID” is 255 as shown in Figure 4
Figure 4: Communication is automatically managed by the software.