Installation & Assembly

3
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. OCT 2019
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
WIRING MULTIPLE UNITS
In addition to hard wiring multiple fixtures, components are
provided to allow fixtures to be linked through surface wiring.
A. END
TO END CONNECTION WITH I-CONNECTOR (FIG.3)
BA-I (One included with each light bar):
The I-Connector allows two fixtures to be connected
end to end. I-Connector has one square and two round pins to
ensure the correct orientation.
NOTE: The total number of all connected fixtures should not
exceed 6 pieces for BA-I.
1. Pry out the Plastic Covers concealing the female
connection ports at the end of the fixtures.
2. Insert one end of the “I” connector into the first fixture.
Slide the second fixture into the first one.
3. Secure the position of the second fixture by using two
mounting screws.
B. CONNECTION WITH INTERCONNECT CABLE (FIG.4)
BA-IC12, BA-IC24, BA-IC36 (Sold Separately)
A jumper wire allows multiple units to be linked through surface
wiring. The jumper wire has one square and two round pins to
ensure the correct orientation.
NOTE: The total number of all connected fixtures should not
exceed 4 pieces for BA-IC12, BA-IC24. 3 pieces for BA-IC36
1. Pry out the Plastic Covers concealing the female connection
ports at the end of the fixtures.
2. Jumper wires have metal strain relief cover brackets. Slide
the cover bracket over the connector.
3. Insert the ends of the Jumper Wire into each fixture.
4. Position the bracket so that the hole in the bracket aligns
with the hole in the fixture. Use the screw supplied to secure
the cover bracket to the fixture.
5. Wrap excess wires using wire ties if necessary.
CCT SWITCHING OPTION FIG.5
Fixture’s CCT can be set to 2700K or 3000K or 3500K by moving
the sliding switch on the fixture as shown.
LIGHT LEVEL OPTION (FIG. 5)
Fixture's light output can be set to 100%, 50% or off by
adjusting the rocker switch on the fixture as shown.
INSTALLATION INSTRUCTIONS
L
ED UNDERCABINET BARLIGHTS
BA-AC08, BA-AC12, BA-AC18, BA-AC24, BA-AC30
FIG.3
FIG.4
FIG.5
I-Connector
Cover bracket
Plastic Cover