Installation & Assembly

2
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. OCT 2019
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION FIG.1
1. Pry open the knock out hole on the Side Door to install the input wires.
2. Unscrew Door Screw and remove the Side Door from the fixture by sliding it to the side.
3. Install the Non-metallic Sheathed Cable into the side door.
4. Push 120V input wires through the Non-metallic Sheathed Cable.
INSTALLATION AND WIRING (FIG.1, FIG.2
1. Strip 3/8” insulation off 120V input wires. Connect input
wires to LED light bars using convenient Wire Connectors
provided with LED light bars. Push 120V input wires firmly
into Wire Connectors for secure connections.
2. Tuck wires connections neatly into LED light bar.
3. Install the side door onto fixture and tighten Door Screw.
4. Take out two Mounting Screws from the package.
5. Screw the Mounting Screws into the fixture.
6. Place fixture in appropriate place and tighten
Mounting Screws.
FIG.2 INPUT WIRE
FIG.1 INSTALLATION AND WIRING
INSTALLATION INSTRUCTIONS
LED UNDERCABINET BARLIGHTS
BA-AC08, BA-AC12, BA-AC18, BA-AC24, BA-AC30
Connect black
input wire to
black xture wire.
Connect white
input wire to
white xture wire.
Connect green ground wire (may
be bare copper) to green xture wire.
Screw Driver
Mounting screw
Side door
Wire
Connector
Door Screw
Non-metallic Sheathed Cable Connector
White
White
Green
Green
Black
Black