Installation Sheet

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. DECEMBER, 2014
PREPARATION
- Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
- Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
1. Remove xture screw (F1) and gasket (G1.)
2. Secure mounting back plate (D1) to the junction box using junction box screws (E1).
The side of the mounting back plate marked “GND” must face out.
CONNECTING THE WIRES (FIG. 2)
3. Connect the supply wires as shown in Fig.1 Fig. 2, making sure that all wire connectors (B1) are secured. If your outlet box has a green or
bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the backplate (D1)
using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (FIG. 1)
4. Place the xture over the mounting backplate (D1)
and secure with xture screws (F1) and gasket (G1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2
Fig. 1
Junction Box
Wire Connector
Mounting Plate
Junction Box Screw
Fixture Screw
Gasket
B1
D1
E1
F1
G1
INSTALLATION INSTRUCTION
Tube - Exterior
WS-W2609, WS-W2610