Installation Sheet

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JANUARY, 2017
INSTALLATION INSTRUCTION
Elementum - dweLED
WS-7222, WS-7230
PREPARATION
1. Shut o the power at the circuit
breaker and remove existing xture,
including the mounting hardware.
2. Carefully unpack your new xture and
lay out all the parts on a clear area. Be careful
not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (C1) from the xture.
4. Place the gasket onto the glass, twist lock the glass onto the xture.
Secure using Allen screw (D1) and Allen wrench (E1) provided.
Note: Caulk the Allen screw using silicone for wet location.
5. Connect the xture wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. Fixture and
junction box ground wires should be connected to mounting plate using green screw provided. After wires are connected,
tuck them carefully inside the junction box. Secure the mounting plate to the junction box using the junction box screws (B1).
The side of the mounting plate marked “GND” must face out.
MOUNTING THE FIXTURE (Fig. 1)
6. Place the xture’s back plate over the mounting plate and secure with the mounting screws (C1).
C1
B1
A1
D1
FIG.1
Mounting
screw
Back plate
Junction box
screw
Mounting
plate
Wire
connector
Junction box
Allen screw
Gasket
Green
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
5 5/8”
7 5/8”
4 1/4”
1 3/4”
1 3/8”
4 1/4”
1 3/4”
1 3/8”
WS-7222 Back Plate Dimensions WS-7230 Back Plate Dimensions