Installation Sheet

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JANUARY, 2017
INSTALLATION INSTRUCTION
Elementum - dweLED
WS-7213
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out all the parts
on a clear area. Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (C1) from the xture.
4. Place the gasket onto the glass, twist lock the glass onto
the xture. Secure using Allen screw (D1) and Allen wrench
(E1) provided.
Note: Caulk the Allen screw using silicone for wet location.
5. Connect the xture wires to junction box wires as shown
in Fig. 2, making sure that all wire connectors (A1) are
secured. Fixture and junction box ground wires should be
connected to mounting plate using green screw provided.
After wires are connected, tuck them carefully inside the
junction box.
6. Secure the mounting plate to the junction box using the
junction box screws (B1). The side of the mounting plate
marked “GND” must face out.
7. Place the xture’s back plate over the mounting plate
and secure with the mounting screws (C1).
C1
B1
A1
D1
FIG.1
Glass
Gasket
Mounting
screw
Junction
box screw
Mounting
plate
Wire
connector
Junction
box
Allen screw
Back plate
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
Back Plate Dimensions
5 5/8”
4 1/4”
1 3/4”
1 3/8”