Installation Sheet

MOUNT ON 4”X4” JUNCTION BOX (Fig. 2)
Fig.1 Mount on Junction Box
Fig. 3 Wiring
2
3. Remove the mounting screw (B) from the xture, and then take down the mounting back plate.
4. The lamp can switch between three color temperatures (2700K-3000K-3500K), which can be adjusted to your preference with the
switch in the canopy (Fig.4).
5. Secure the mounting ring (E) to the junction box using junction box screws(D).The side of the mounting ring marked “GND” must face
out.
6. Secure the mounting back plate and conversion plate (F) to the mounting ring(E) with the Assembly screws(C).
7. Connect the
xture’s wires to junction box wires as shown in Fig. 3, making sure that all wire connectors (A) are secured. If your outlet
box has a green and bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’ ground wire
directly to back plate using the GND screw provided.
After wires are connected, tuck them carefully inside the junction box.
8. Secure the xture to the mounting back plate using the mounting screw(B).
Black or
Smooth
White or
Ribbed
Bare wire
(Ground)
Black
(Hot)
White
(Neutral)
Green or Bare C
opper
(Ground)
Conversion Plate
Mounting Plate
F
Mounting Ring
Junction Box Screw
Assembly Screw
E
D
C
Junction Box
Fig.4 Switch
3000K3500K 2700K


Phone [phone]
Fax [phone]

44 Harbor Park Drive
Port Washington, NY 11050

1600 Distribution Ct
Lithia Springs, GA 30122

1750 Archibald Avenue
Ontario, CA 91760
3
INSTALLATION INSTRUCTION

WS-53223