Installation Sheet

PREPARATION
MOUNT ON 2”X4” SWITCH BOX (Fig. 1)
Fig.1 Mount on Switch Box
4. The lamp can switch between three color temperatures (2700K-3000K-3500K), which can be adjusted to your preference with the switch
in the canopy (Fig.4).
5. Secure the mounting plate to the switch box using Assembly screws(C).The side of the mounting back plate marked “GND” must face out.
6. Connect the
xture’s wires to junction box wires as shown in Fig. 3, making sure that all wire connectors (A) are secured. If your outlet box
has a green and bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’ ground wire directly to
back plate using the GND screw provided.
After wires are connected, tuck them carefully inside the switch box.
7. Secure the xture to the mounting back plate using the mounting screw (B).
OR
Conversion Plate Dimensions
Mounting Ring Dimensions
Back Plate Dimensions
3. Remove the mounting screw (B) from the xture, and then take down the mounting back plate.
1. Shut off the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for
installation.
GN
D
1 3/4” 1 3/8”
φ4"
B
Mounting Screw
A
Wire Connector
Ground Wire
Mounting Plate
Assembly Screw
C
3CCT Switch
Fixture
Switch Box
2 1/2”
1 3/8”
1 5/8”
4 1/2”
1 3/8”
1 5/8”
5”
5 1/2”


Phone [phone]
Fax [phone]

44 Harbor Park Drive
Port Washington, NY 11050

1600 Distribution Ct
Lithia Springs, GA 30122

1750 Archibald Avenue
Ontario, CA 91760
2
INSTALLATION INSTRUCTION

WS-53223