Installation Sheet

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER 2020
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
FLO
WS-224, WS-236, WS-248
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Drill holes in the wall aligned with the key-hole location in the mounting plate (C1).
4. Insert the mounting anchors (O1).
5. Connect the fixture input wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured.
If your outlet box has a ground wire (I1) (Green or bare copper), connect the fixture’s ground wire to it.
After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1)
6. Secure crossbar (D1) to the junction Box using junction box screws (B1).
The side of the mounting plate marked “GND” must face out.
7. Place the mounting plate (C1) to the threaded nipple (K1) at the crossbar
and fasten the hex nut (N1) onto the nipple (K1).
8. Fasten the wood screws (M1) into the mounting anchors (O1).
Tighten the mounting plate (C1) on the wall.
9. Select the desired Color Temperature by setting the sliding switch
to the target CCT (See Fig. 3).
10. Place the diffuser (G1) onto the mounting plate (C1)
and secure to the mounting plate (C1) using end finials (J1).
K1
M1
G1
D1
B1
I1
C1
A1
O1
J1
Junction box
Threaded Nipple
Wood Screw
Di
ffuser
Crossbar
Junction Box Screw
Ground Wire
Mounting Plate
Keyholes
Wire Connectors
Mounting Anchor
End Finials
FIG 1
N1
Hex Nut
2700K
3000K
3500K
4000K
5000K
Fig.
3