Installation & Assembly

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014
INSTALLATION INSTRUCTION
W Track Recessed 277V Flange
WHT4-RT, WHT8-RT, WHT12-RT
SAFETY INSTRUCTION
• Read all of these instructions before installing the track system.
• Turn o power at main switch before installing or modifying the system.
• Do not install within six inches of any curtain or combustible materials.
• Do not install less than 5 feet above a oor.
• Do not install in damp or wet locations.
• Do not install concealed, or extended through building walls.
• Do not attempt to energize anything other than a track light xture.
• This track system shall only be supplied with two single 120V, 60Hz, 20amp branch circuits.
• Do not load to more than 20 amps per circuit. Although track light systems may seem to operate acceptably,
a dangerous overload of the neutral may occur and result in a risk of re.
• Check with a qualied electrician before wiring.
• All of the installations shall be in accordance with NEC and all local codes.
• Save these installation instructions and refer to them when additions or changes to the track conguration are made.
MOUNTING OPTIONS
Generally, for any mounting method, do not exceed 4 feet between mounting points, and do not exceed 6 inches
(for 4 feet of track or less in length) or 12 inches (for track that is greater than 4 feet) from each end of the single track section.
Always use two or more mounting supports for each track length.
A: STRAP MOUNTING
• Remove the End Cap and save.
• Slide the perforated hanger straps (not included, can be
purchased in a hardware store) into the groove in the side of
the track. An equal number of straps should be mounted on
each side of the track.
• Wrap the straps around the building structure or nail the
straps to the structure. They should be positioned evenly to
balance the track.
• Placing one hanger strap every foot per side is recommended.
• Push End Cap into the track at the end of the track
and secure by screw.
• The hanger strap can be bought at a hardware store,
recommend size is 11/16 inch (17mm) in width.
• Use clips or plates (by others) to be accommodated mounting
on the 1/2 inch of the ceiling board.
B: DIRECT MOUNTING
• Mounting slots in top of track can be knocked out and are
spaced every 10 inches for convenience.
• Mount as shown using a mounting screw every 2 feet
is recommended.
• Additional supports may be added for heavier
load applications.